Laptop goes into “preparing automatic repair” loop when trying to start and BSODs with a different reasons every time

Understanding and Troubleshooting the “Preparing Automatic Repair” Loop and Blue Screen Errors on Your Laptop

Are you experiencing a frustrating issue where your laptop continually gets stuck in a “Preparing Automatic Repair” loop and displays different Blue Screen of Death (BSOD) errors? If you’re not very familiar with technical troubleshooting, don’t worry — this guide aims to explain the situation clearly and offer some straightforward steps you can try to resolve the problem.

What is happening to my laptop?

Based on your description, your laptop during startup repeatedly attempts to boot normally but is interrupted by a repair loop. It begins to diagnose itself, briefly enters the “Preparing Automatic Repair” mode, then restarts, only for the cycle to repeat. Occasionally, instead of booting properly, the system crashes with a Blue Screen error, displaying different stop codes each time.

Common Error Codes You Mentioned

KMODE_EXCEPTION_NOT_HANDLED
DRIVER_OVERRAN_STACK_BUFFER
IRQL_NOT_LESS_OR_EQUAL

These variations suggest that the cause could be related to driver issues, hardware conflicts, or system corruption.

Possible Causes

While it’s tough to diagnose without direct access, common reasons for such problems include:
– Corrupted system files or Windows installation
– Faulty or incompatible device drivers
– Hardware issues, such as failing RAM or storage drives
– Recent updates or changes made to your system

Basic Troubleshooting Steps

Here are some gentle steps you can follow to attempt to fix the problem:

Perform a Hard Reboot
Turn off your laptop completely, wait a few seconds, then turn it back on. Sometimes, a simple reboot can resolve temporary glitches.
Boot into Safe Mode
When your laptop begins the startup process, turn it off abruptly (hold the power button). Do this 3 times, and Windows should enter the Advanced Startup Options.
From there, select “Troubleshoot” > “Advanced options” > “Startup Settings” > “Restart.”
After rebooting, press the number corresponding to “Enable Safe Mode” (usually 4 or 5).
If you can boot into Safe Mode, it indicates the issue may be caused by drivers or software.
Uninstall Recently Installed Drivers or Updates
If Safe Mode loads successfully, try uninstalling any recent updates or drivers that might be causing conflicts.
**Run